Difference between revisions of "WCmore's AddDevices"

From webCoRE Wiki - Web-enabled Community's own Rule Engine
Jump to: navigation, search
m (Adding devices to webCoRE)
m (Adding devices to webCoRE)
 
(4 intermediate revisions by the same user not shown)
Line 6: Line 6:
 
* Select a category, and place a check-mark next to any device that you want webCoRE to see and/or control
 
* Select a category, and place a check-mark next to any device that you want webCoRE to see and/or control
 
(If you don't see the device, go to the bottom of the available devices page & under Select devices by capability, try another Group)
 
(If you don't see the device, go to the bottom of the available devices page & under Select devices by capability, try another Group)
* Save multiple times until you are back in the SmartApps page
+
* Once there's a check-mark by the new device, save multiple times until you are back in the SmartApps page
 
* You can now use this device in webCoRE.  If you still do not see it, try a hard refresh to your [https://dashboard.webcore.co/ Dashboard].  (''Ctrl-F5'')
 
* You can now use this device in webCoRE.  If you still do not see it, try a hard refresh to your [https://dashboard.webcore.co/ Dashboard].  (''Ctrl-F5'')
 +
-----
 +
 +
Pro Tip: It's probably good advice to avoid adding new devices while in the middle of editing a piston.
  
 
{{WCmoreTOC}}
 
{{WCmoreTOC}}

Latest revision as of 23:26, 4 August 2020

Adding devices to webCoRE

  • Connect the device to SmartThings first
  • Test the device using the SmartThings app on your phone to make sure the new device is working thru the hub
  • Add the device to webCoRE by going to: Automation > SmartApps > webCoRE > Settings > Available devices > Available devices
  • Select a category, and place a check-mark next to any device that you want webCoRE to see and/or control

(If you don't see the device, go to the bottom of the available devices page & under Select devices by capability, try another Group)

  • Once there's a check-mark by the new device, save multiple times until you are back in the SmartApps page
  • You can now use this device in webCoRE. If you still do not see it, try a hard refresh to your Dashboard. (Ctrl-F5)

Pro Tip: It's probably good advice to avoid adding new devices while in the middle of editing a piston.



WCmore's Tips - Table of Contents











.