Difference between revisions of "WCmore's Tips"
From webCoRE Wiki - Web-enabled Community's own Rule Engine
m (→Adding devices to webCoRE) |
m (→Simulated Switches) |
||
| Line 20: | Line 20: | ||
Sometimes I have to use an "Incognito" or "Private Browsing Window" to be able to log into the IDE. | Sometimes I have to use an "Incognito" or "Private Browsing Window" to be able to log into the IDE. | ||
| − | Once the device is added, ST will see it within a few seconds, but you will also have to | + | Once the device is added, ST will see it within a few seconds, but you will also have to add the device to webCoRE. |
--- | --- | ||
Revision as of 23:53, 19 March 2019
Contents
Hello, and welcome...
This is a collection of tips that work well for me. Stay tuned for more Tips & Tricks...
Simulated Switches
I hear people talk about "Virtual Switches" as well as "Simulated Switches". Personally, I will only recommend using "Simulated Switches", since I have seen a lot of errors lately involving virtual switches.
To create a SimSwitch, I use a web browser to:
- Log into the IDE
- Choose “My Devices” at the top
- Click on “+ New Device” in the top right
Then use the image on the left as a guide:
Side Note: Sometimes I have to use an "Incognito" or "Private Browsing Window" to be able to log into the IDE.
Once the device is added, ST will see it within a few seconds, but you will also have to add the device to webCoRE.
---
Adding devices to webCoRE
- Connect the device to SmartThings first
- Toggle the device using the SmartThings app on your phone to make sure it is working
- Add the device to webCoRE by going to: Automation > SmartApps > webCoRE > Settings > Available devices > Available devices
- Select a category, and place a check-mark next to any device that you want webCoRE to see and/or control
- Save multiple times until you are back in the SmartApps page
- You can now use this device in webCoRE. If you still do not see it, try a hard refresh to your Dashboard. (Ctrl-F5)
