Difference between revisions of "WCmore's AddDevices"
From webCoRE Wiki - Web-enabled Community's own Rule Engine
m (→Adding devices to webCoRE) |
m (→Adding devices to webCoRE) |
||
| Line 8: | Line 8: | ||
* Once there's a check-mark by the new device, save multiple times until you are back in the SmartApps page | * Once there's a check-mark by the new device, save multiple times until you are back in the SmartApps page | ||
* You can now use this device in webCoRE. If you still do not see it, try a hard refresh to your [https://dashboard.webcore.co/ Dashboard]. (''Ctrl-F5'') | * You can now use this device in webCoRE. If you still do not see it, try a hard refresh to your [https://dashboard.webcore.co/ Dashboard]. (''Ctrl-F5'') | ||
| + | |||
| + | Pro Tip: It's probably good advice to avoid adding new devices while in the middle of editing a piston. | ||
{{WCmoreTOC}} | {{WCmoreTOC}} | ||
Revision as of 23:25, 4 August 2020
Adding devices to webCoRE
- Connect the device to SmartThings first
- Test the device using the SmartThings app on your phone to make sure the new device is working thru the hub
- Add the device to webCoRE by going to: Automation > SmartApps > webCoRE > Settings > Available devices > Available devices
- Select a category, and place a check-mark next to any device that you want webCoRE to see and/or control
(If you don't see the device, go to the bottom of the available devices page & under Select devices by capability, try another Group)
- Once there's a check-mark by the new device, save multiple times until you are back in the SmartApps page
- You can now use this device in webCoRE. If you still do not see it, try a hard refresh to your Dashboard. (Ctrl-F5)
Pro Tip: It's probably good advice to avoid adding new devices while in the middle of editing a piston.
| ▲ WCmore's Tips - Table of Contents ▲ |
.
